Buick Enclave manuals

Buick Enclave: Engine Oil Messages. Engine Power Mes. Fuel System Messages

Buick Enclave 2008-2017 Owners Manual / Instruments and Controls / Information Displays / Engine Oil Messages. Engine Power Mes. Fuel System Messages

Engine Oil Messages

CHANGE ENGINE OIL SOON

This message displays when the engine oil needs to be changed.

When you change the engine oil, be sure to reset the CHANGE ENGINE OIL SOON message. See Engine Oil Life System  for information on how to reset the message. See Engine Oil  and Maintenance Schedule  for more information.

OIL PRESSURE LOW STOP ENGINE

Notice: If you drive the vehicle while the engine oil pressure is low, severe engine damage may occur. If a low oil pressure warning appears on the instrument panel cluster and/or DIC, stop the vehicle as soon as possible. Do not drive the vehicle until the cause of the low oil pressure is corrected.

See Engine Oil  for more information.

This message displays if low oil pressure levels occur. Stop the vehicle as soon as safely possible and do not operate it until the cause of the low oil pressure has been corrected. Check the oil as soon as possible and have your vehicle serviced by your dealer. See Engine Oil

Engine Power Mes

ENGINE POWER IS REDUCED

This message displays and a chime sounds when the cooling system temperature gets too hot and the engine further enters the engine coolant protection mode.

See Engine Overheating  for further information.

This message also displays when the vehicle's engine power is reduced. Reduced engine power can affect the vehicle's ability to accelerate. If this message is on, but there is no reduction in performance, proceed to your destination. The performance may be reduced the next time the vehicle is driven. The vehicle may be driven at a reduced speed while this message is on, but acceleration and speed may be reduced. Anytime this message stays on, the vehicle should be taken to your dealer for service as soon as possible.

Fuel System Messages

FUEL LEVEL LOW

This message displays and a chime sounds if the fuel level is low. Refuel as soon as possible.

See Fuel Gauge  and Fuel  for more information.

TIGHTEN GAS CAP

This message may display along with the check engine light on the instrument panel cluster if the vehicle's fuel cap is not tightened properly. See Malfunction Indicator Lamp . Reinstall the fuel cap fully. See Filling the Tank . The diagnostic system can determine if the fuel cap has been left off or improperly installed. A loose or missing fuel cap allows fuel to evaporate into the atmosphere. A few driving trips with the cap properly installed should turn this light and message off.

READ NEXT:

 Key and Lock Messages. Lamp Messages. Object Detection System Messages

Key and Lock Messages REPLACE BATTERY IN REMOTE KEY This message displays if a Remote Keyless Entry (RKE) transmitter battery is low. The battery needs to be replaced in the transmitter. See “Ba

 Ride Control System Messages. Airbag System Messages. Anti-theft Alarm System Messages

Ride Control System Messages SERVICE STABILITRAK This message displays if there is a problem with the StabiliTrak® system. If this message appears, try to reset the system. Stop; turn off the engi

SEE MORE:

 Manual Mode. Tow/Haul Mode

Manual Mode Electronic Range Select (ERS) Mode ERS mode allows you to choose the top-gear limit of the transmission and the vehicle's speed while driving downhill or towing a trailer. The vehicle has an electronic shift position indicator within the instrument panel cluster. When using the

 CD Player

Playing a CD Insert a CD partway into the slot, label side up. The player pulls it in and the CD should begin playing. EJECT: Press and release to eject the disc that is currently playing. A beep sounds and Ejecting Disc displays. Once the disc is ejected, Remove Disc displays. The disc can

© 2016-2024 Copyright www.benclave.com