Buick Enclave manuals

Buick Enclave: Power Outlets. Sunroof

Buick Enclave 2008-2017 Owners Manual / In Brief / Vehicle Features / Power Outlets. Sunroof

Power Outlets

The vehicle has 12-volt accessory power outlets which can be used to plug in electrical equipment, such as a cell phone or MP3 player.

The power outlets are located:

► On the instrument panel below the climate controls.

► Inside the center floor console.

► At the rear of the center floor console.

► In the rear cargo area.

To use the outlets, remove the cover.

See Power Outlets .

Sunroof

The ignition must be in ON/RUN or ACC/ACCESSORY to operate the sunroof and power sunshade.

See Retained Accessory Power (RAP) .

The vehicle may have a sunroof over the front seats and a rear sunroof over the second row seats.

The rear sunroof does not open.

The switch to operate the front sunroof is on the headliner above the rearview

The switch to operate the front sunroof is on the headliner above the rearview mirror.

Vent: Press the front or rear of the switch to vent or close the sunroof.

Express-open/Express-close:

From the closed position, press and release the rear or front of the switch to express-open or express-close the sunroof.

Manual Sunshade

The front sunshade must be opened and closed manually.

To open the sunshade, press the button on the sunshade handle to release it and guide it back.

To close the sunshade, pull the sunshade forward until it latches.

For more information see Sunroof .

READ NEXT:

 Performance and Maintenance

 StabiliTrak® System. Tire Pressure Monitor. Tire Sealant and Compressor Kit

StabiliTrak® System The vehicle has a traction control system that limits wheel spin, and the StabiliTrak system that assists with directional control of the vehicle in difficult driving conditio

SEE MORE:

 Description and Operation

EXHAUST SYSTEM DESCRIPTION IMPORTANT: Use of non-OEM parts may cause driveability concerns. The exhaust system carries exhaust gases, treated by the catalytic converter, through a resonator, if applicable and into the exhaust muffler where exhaust noise is lessened. In order to secure the exhaust

 Specifications, Diagnostic Information and Procedures

SPECIFICATIONS FASTENER TIGHTENING SPECIFICATIONS Fastener Tightening Specifications SENSOR RESISTANCE TABLE Sensor Resistance Table SCHEMATIC WIRING DIAGRAMS HVAC SYSTEM WIRING SCHEMATICS Power, Ground, Blower Control and Subsystem References Fig. 1: Power, Ground, Blower Control and Subsystem R

© 2016-2024 Copyright www.benclave.com